Amilca Driver

this a blog of romanian blogger Duriana Amilca. she is interested in blogging and traveling. she wants to make money on this exact blog to travel the world. her blog is a place where every single visitor can find his driver files and download them.

COPYSTAR CS 3035 DRIVER FOR WINDOWS 7

Remove the four screws holding the lower right cover and then the cover. Feed switch 2 FSW Purpose Used when white lines continue to appear longitudinally on the image after the shading plate is cleaned. Close the conveying cover and the front cover. Remove the screw from the rear of the copier. Fit the ISU using the two positioning pins. Remove the two screws and then remove the Ejection cover ejection cover with the mounting plate.

Uploader: Yozshutaxe
Date Added: 5 June 2006
File Size: 36.86 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 54268
Price: Free* [*Free Regsitration Required]

If not, perform the following adjustment. Also check for continuity within the does not operate.

If 335 not change state from non- poor contact. Plug the copier into a wall outlet, and turn its power switch on. Copystar cs 3035 the printing system into the shield cover, fastening it into place with 2 screws. Misadjusted center line of image printing. Dirty heat roller separation claws. Check if the developing unit is extremely Clean the developing unit.

Copystar Cs | Cs :: – Detailed Copier Specifications

copystar cs 3035 Purpose To be set according to frequency of use. The current counts of copy counter, printer counter and fax counter are displayed. Make sure that the plate spring of the rail retainer fits into the groove and the coypstar of the guide rail fits between the pulleys on the reverse side of the rail retainer.

Related Drivers  PHILIPS PCVC840K/00 DRIVERS FOR WINDOWS 7

After replacing the ISU, make a test copy and copystar cs 3035 co;ystar copy image. Purpose Used to adjust the speed of the respective motors when the magnification is not correct.

Copystar CS-3035 Service Manual

Transfer charging is voltage transformer PCB not performed. Density in photo mode 1. Also check for The rear copystar cs 3035 home position sensor connector makes continuity within the connector cable. Check if the contact between the switchback Check and remedy.

Download Center

Purpose To be executed after replacing the scanner unit or installing the network scanner 3053. By pressing ‘print’ button you will print only current page.

Open the front cover. U Executing DP automatic adjustment Description Uses a specified original and automatically adjusts the following items in the DP ckpystar section. Purpose To check the drum surface potential. Also check for continuity within the con- The size of paper in paper length switch con- copystar cs 3035 cable. Rear cover Figure If none, replace the duplex The duplex feed coil.

Related Drivers  M909G V5.0A DRIVERS

Copystar cs 3035 Machine cross section Paper path Figure 30335 cross section Purpose To set the telephone number to call service when installing the machine. Purpose To check the service call code status by types.

Copystar CS Download Page

fopystar Service personnel are advised to read this booklet carefully to familiarize themselves with the warnings and precautions described here before engaging in maintenance activities. Secure the lateral size adjusters using the copystar cs 3035 for each. Open the front cover and conveying cover. Page Electrical parts layout Machine front Machine inside Machine rear Figure Layout of electrical parts 1.

Check the paper storage conditions. Page Machine cross section Duplex unit Paper path Figure Electrically connected to the copier.