Purpose To be reset after partial operation is performed due to problems in the drawers or other sections, and the related parts are serviced. Remove the two screws securing the feedshift guide assembly and then the assembly. Open the conveying cover. Lower side is longer. Release the hook of the switchback unit by lifting the release lever. Remove 13 screws and take off the rear Rear cover cover. The KX Driver gives you full access to and control over all paper resources, publishing features and advanced finishing capabilities.
|Date Added:||2 April 2008|
|File Size:||8.51 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Purpose To change the setting according to the type of the cooling f a n. Page Mechanical construction The paper feed desk feeds paper from either of its two drawers to the copier main body.
Lift the stapler unit further up, and then lower Difference between the maximum and the minimum of applied voltage 1. This operation should be performed when the 2. Paper jams in the copy paper is caught switchback unit when around the switchback the main switch is eject switch and switchback turned on. Page Machine cross section Paper path Figure Purpose To check the current setting of the maintenance copustar, or paper jam or service scannerr occurrences.
To remove paper jammed in the copier, open the front cover, conveying cover, side cover or drawer.
U Setting the type of cooling fan Description Sets the new or old type of cooling fan. Here’s a link to this great service Good luck!
U U U U Controls the electrical components. Caution Before making this adjustment, ensure that the following adjustments have been made in maintenance mode. Lately during the filling cycle water hammer is occurring. Switchback feed motor SBFM Install the optional paper feeder or large cs-305 deck.
Connect the connector of the DP to the copier. The current counts of copy counter, printer counter and fax counter are displayed.
Specifications | Copystar – CS-3035 Printer
Main switch Power label Figure With KM-NET Viewer, Administrators can oversee the network configuration, check paper levels, change device defaults, and view meter counts. Misadjusted center line of image printing. Attach the copy tray.
Get the Android App. Scsnner is applied by the fixing unit pressure springs so that the toner on the paper is melted, fused and fixed onto the paper. If lateral squareness is still not obtained, perform ” 6 Adjusting the position of the ISU” Purpose To check if the sensors and s witches operate correctly.
Related Topics scanner 6 scanner manual error kyocera error da 30 kyo sc pc kyocera scan sc 30 CS 30 PO hv 30 IP Kyocera Kyocera pc Kyocera error copystar ip address ip address kyocera error Comments to this Manuals Your Name.
Feed switch 2 FSW Primary paper feed from the upper drawer.
This is an optional device which is currently supported only by Japanese specification machines, so no setting is necessary. Push the hard disk all the way scanjer along the rails, and fasten it with 2 screws. If the image is incorrect, perform the adjustments see pages to Jam in the mailbox 2 See the mailbox service manual.